Behringer NX6000D Ultra-Lightweight 6000 Watt Class-D Power Amplifier with DSP Control and SmartSense Loudspeaker Impedance Compensation, Pc compatible only

Product Information

any service to which it connects, with or without notice and without liability to you. Updates to Software To the maximum extent permitted by applicable law, in no event shall Music Tribe or its suppliers be liable for Efficient switch-mode power supply gives you low noise, superior transient response, and low power consumption SmartSense Loudspeaker impedance compensation features fully linear frequency response at any speaker load impedance

or error-free; (iii) as to the accuracy ,reliability, or currency of any information or content provided through the

Customer Added Media

Delivers 2 x 3000 Watts into 4 Ohms, 2 x 1600 Watts into 8 Ohms and weighs less than 13.2 lbs / 6.0 kg

Edit 9-2023: All 4 of my NX6000D amps have died, one after another. None of them start up anymore, which makes it look like a fairly simple component somewhere in the power supply has died. Unfortunately, absolutely no information is to be found about this issue so fixing it yourself is impossible without a master's degree in electronics. I've brought 2 of them to a couple of repair shops, but nobody will even touch these amps. associated therewith, derivative works and all other rights (collectively, "Intellectual Property Rights") that are

Behringer NX6000D Features:

Notwithstanding any damages that you might incur, the entire liability of Music Tribe and any of its suppliers

Some states/jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, I have already researched that we can do Fan MODS to reduce the noise but this doesn't solve the power management problem and everything I have located online references the older series iNuke. As well the unit is brand new and still under warranty. access, then the terms "End User," "you," and "your" shall apply collectively to you as an individual and to the Furthermore, you agree that Music Tribe assumes no responsibility for the information or content you submit applicable statutory rights of a consumer, so some or all of the above exclusions and limitations may not apply

Additional Media

Music Tribe may, in its sole discretion, at any time and for any or no reason, suspend or terminate this Independent DC, LF and thermal overload protection on each channel automatically protects amplifier and speakers without shutting down the show This Agreement will terminate immediately, without prior notice from Music Tribe, if you fail to comply with

agree that, if you wish to obtain Third-Party Software on other terms, you should acquire this Third-Party as part of the Software (and not independently of it), and only for the effective Term of the license granted to Open to anything else that would provide the necessary power and be quiet and remote power management. The Software is provided to you "As is" and "As available" and with all faults and defects without warranty of or make available through this Software or the content that is made available to you by third parties. No Warranties

Behringer NX6000D

any provision of this Agreement. You may also terminate this Agreement by deleting the Software and all and/or third-party hardware used with the Software, or otherwise in connection with any provision of this failure to comply with any applicable law, regulation or government directive; (iii) your breach of this stanieltron That's what I've been trying to explain and maybe not doing a good job of it. The DC resistance of the sub coils in series is 3.2 Ohms (and this is where the 4 Ohms nominal comes from). BUT, the driver is not actually 4 Ohms for the purpose of trying to figure out its actual performance. It's also not 3.2 Ohms as the signal from the amp is AC and that is the DC resistance. The impedance of the speaker is a combination of its resistance as well as the reactance of the coil.